fms atlas 6x6 3d models
6787 3d models found related to fms atlas 6x6.
thingiverse
Simple stands for FMS 1:6 and 1:10 platform (not yet tested on Willys). Requires 2 sides, one low-beam and a pair of leaf-spring or links upper-beams according to your truck. ... 21-09 : updated the beams for links with better clearance and shape
thingiverse
Here is a rear bumper for the FMS K10 / Eazyrc Glacier model. The top of it is hinged so it can be opened up and used as a toolbox. This is based off of an actual aftermarket one that was available years ago. To build it you will need two #1-72 x...
prusaprinters
This is a tow release for the FMS Fox 2300mm V2 glider. It is shaped to fit into front cooling vent, and includes a channel to allow air to continue to flow through the vent. To complete the tow release you will need: 9g Servo - such as HXT900 or...
thingiverse
This is an in bed toolbox for the FMS K10 and Eazyrc Glacier RC model. It attaches with a clamp block on either side that pinches the bedrail so there's no need to drill any holes or glue it to your model. If desired it also uses two magnets to act...
thingiverse
This design is specifically intended for an FMS Futura front gear door. Once printed, do not allow it to cool down excessively, as this will make removal from the print bed more challenging. Instead, carefully remove it when it's still warm enough to...
myminifactory
If you want to set your FMS FCX24 apart from the rest, these period-correct tube bumpers will do the trick. The original screws are used to hold them on and as a side note, the geometry on the bumper straitens the front and rear panels on the body as...
myminifactory
This camper shell will fit the FMS FCX18 K10 Checy Truck, 1/18 K10 and Eazy RC Glacier. This has been printed in SLS Nylon, FDM PLA, and SLA ABS-Like resin. This will fit in the bed of the aforementioned truck beds without any modifications to the...
cults3d
FMS Ranger 1800 Strut End Replacement If you are like me then you would have snapped the end of the strut due to transporting the plane. Having found out it is hard to purchase, I decided to redesign my own version. I had to drill out the old broken...
thingiverse
The stock FMS F/A-18 wingtip missile rail is made of EPO foam, which is soft, fragile and unattractive. This rail slots into the same wingtip mounts as the original equipment. To simplify printing, the mounting lugs are printed separately and glued...
thingiverse
FMS Ranger 1800 Strut End Replacement If you are like me then you would have snapped the end of the strut due to transporting the plane. Having found out it is hard to purchase, I decided to redesign my own version. I had to drill out the old...
cgtrader
------------------Puma 6x6 Military vehicle----------------------------