filawinder 3d models

The upper section of the framework is engineered to securely latch onto 3/4-inch plywood boards that will be used as a base for the entire system with filawinder. A few longer M3 screws are required to attach the hopper to the case securely. One...

The size of the flanges is calculated to work seamlessly with the FilaWinder from ianjohnson, available at http://www.thingiverse.com/thing:174383. This winder removed about 1 kg of filament with a diameter of 1.75 mm. ...Check out the video below to...

Three Part Spool Designed for Robo 3D I needed a sturdy spool that could handle a pound of filament when used with my Filastruder and Filawinder. A spool with complete sides and bottom was essential to keep the filament wound neatly. Once assembled,...

This modification adds approximately 5cm to the original dimension, perfectly suiting my Filawinder setup. I would like to extend gratitude to the original creator for sharing their CAD files. In a similar gesture, I have included the corresponding...

The version depicted uses a salvaged gearmotor from my junk box, but I've redesigned it to accept the same gear motor that shipped with my Filawinder (PM-33126000-180K, 12V). This gearmotor is likely beefier than necessary for this build, but...

...It is designed for use with my vertical auger assisted hopper and improved wall mounted sensor for the filawinder. The viewport window is designed to be cut from a 1.5mm thick CD/DVD jewel case. A template is provided to help cut that part to size.

It is designed for use with my vertical auger assisted hopper and improved wall mounted sensor for the filawinder. The viewport window is designed to be cut from a 1.5mm thick CD/DVD jewel case. There is a template provided to help cut that part to...

In my experiments with reclaiming waste prints on my wall mounted filastruder I found that the shredded material could quite easily get hung up in the chute, and I was constantly having to bang on it to keep the extruder screw fed with material. To...