f1 pushrod suspension 3d models
16865 3d models found related to f1 pushrod suspension.
Small control horn - suits 6mm foam and ~1.2mm pushrod
thingiverse
thingiverse
**The dimensions are the height of the holes above the surface of the FOAM when installed.** Using a typical 9g servo with my clamp mount, the pushrod is 18mm above the surface of the foam. Therefore a 18mm hole height gives a control range...
LS1 LS2 LS3 LS6 LS7 lifter & pushrod holder
thingiverse
thingiverse
I rounded upwards so there will be a little lose fitting, pushrods come out at 7,9375mm and I made these holes 8mm and the lifters are at 21,3868mm and I made these to 22mm (might have been a little too lose on the lifters but I think they will work...