exposive 3d models

Verify that the prism sits flush with the front aperture all the way around.Clean up any exposed faces of the prism with a lens/microfibre cloth or cotton-bud, dampened with lens cleaning solution or isopropyl alcohol. Avoid spraying the cleaner into...

Being exposed to nuclear material dumped into the ocean, a prehistoric marine lifeform developed an ability to feed on radiation and mutate into a gigantic creature. The powers that the monster was endowed with make Shin Godzilla seemingly...

Just be careful to fold the crimp tabs over one at a time, being sure to secure the strain relief first over the insulated part of the wire, and then crimping down the tabs over the exposed conductor.When crimped correctly, no soldering is needed. If...

Depending on the depth of the screw holes in your motor and whether you're using that bracket, the screw length will vary, in the 10 to 17 mm range.Rotate the printed gears so that the small gear's set screw is exposed to the access hole on the side...

Rather than remove and remount it (possibly leaving a hole exposed), I decided to just use my Dremel tool to cut off the corner from the top of the spool holder, so the door above could swing over it. ***Note:*** I drilled 5/16" holes in each...

 I moved many other things in the garden to safety, but deliberately exposed the wind wheel to the elements. It was clear to me that the thin sails were the weakest point of the construction. They withstood the strong wind for a surprisingly...

The exposed pad underneath this screw is connected to the ground plane of the PCB.If you purchased the hardware kit, you can skip to step 6 as these wires will come pre-assembled.Cut the 16 AWG wire to 11.5cm (4.5") and strip the ends.Cut the red 22...

Unlike your consumer electronics the LiPo cell is very much exposed in RC and special care must be taken. RC Review and FliteTest do some good youtube vids on the matter) : - Cat Grumpiness - 3S LiPo power pack (I was able to find a 1300 mAh...

print with, so.... If you print almost everything in PETG with 2 mm shells, using 40% triangles infill, and print the blower nozzle in ABS using the lightest settings that still produce a usable part (since it needs the heat resistance and won't be...

The angle gives the filament a natural loop shape as it goes through it to reduce friction.  PRUSA BUFFERIf using a Prusa MMU3 Buffer, you need to first remove the long attachment arm part and print more of the smaller bars to cover any exposed...