eibos 3d models

I needed the other side also to lock a teflon tube from my EIBOS Cyclops so the filament is totally contained. This setup is for my "light industrial" materials printer (500C rated, integrated filament dryer system). Nothing special about this...

This allows the tube to feed properly, which It did not do when I used a center guide with a ½ inch diameter hole.I printed in Prusament PETG, with supports, 15% infill.I have included the Fusion 360 file, the STL file and the G code...

I wanted to pop a spool into an EIBOS Easdry filament dryer, but the cores from the original were too thick to fit the peg they needed to rotate on. The wall thickness was 4.5mm, which seems far thicker than this really needs. Since the insert is...

But for those like me who have other stuff taking up space up there (Eibos filament dryer mount) I found a 60mm diameter was a much easier fit while still functioning perfectly. See included images for the build guide. **PS.** Remember to...

So I just received my new Sunlu S2 Filament Dryer and it had the chance to be better than my current favourite, the Eibos Easydry. It gets hotter internally and heats evenly from all sides. There are however two major design flaws that keep it from...

I initially purchased the needle roller bearing to put on my Eibos Easdry because the ribs around the internal core were hindering the smooth rolling of the spool at times. Later realized this bearing comes in 3 pieces, not very practical to be...

Used to prevent the filament inside of the Teflon tube (with filament in it) from being bent at too sharp an angle. I use two EIBOS heat boxes with my two printers on a rack. Previously, I had just zip-tied the Teflon tube to the shelf above. This...

I was unable to find hatchbox filament clips online that are AMS and EIBOS Polyphemus compatible. So I decided to remix my own clips. This clip design is a significant overhaul over remix source, width/height/depth, prongs are all completely...

So I just received my new Sunlu S2 Filament Dryer and it had the chance to be better than my current favourite, the Eibos Easydry. It gets hotter internally and heats evenly from all sides. There are however two major design flaws that keep it from...

Makes for an awesome spacecraft landing area and I have more plans for it in the future.Size: 20 CM x 20 CM or 8 inches X 8 inches4mm thick or 1/16 inch thickPrinted at .2 mmUse a dryer if possible: EIBOS Filament Dryer - it keeps the filament...