edc bit holder 3d models

Simplified to have only necessary. ... Put up to undred bit and the stock holder. ... Caution, will only fit for precision screwdriver bit like the wowstick's bits

Simple 10 hex bit holder. Made it deep to hold 2" long torx bits but should work for any other bit. ...Compact to save room on your workdesk.

Made a bit holder to hold my proto bit set onto pegboard. ...This holds 90 1/4" hex bits and mounts onto standard peg board.

This is a versatile hex bit holder designed to securely store up to 16 standard hex bits, while also providing space to accommodate spade bits with ease.

A drill bit holder to bolt on to another surface. This way the bits don't fall trough. ... Category: Tool Holders & Boxes

... (four is even better), as it might be slightly too tight for hard plastics. * Six-bit holder * 17-bit handle with hanger holes * 18-bit holder with mounting for hanging * Forty-bit holder * Forty-bit holder with mounts https://youtu.be/FMcLOF-PqWU

holder for drill bits or Jewelery pens or any there is place for hand carry on

Did not find a hex bit holder that worked for me, so I made my own.

Magnetic bit holder neodymium magnet 5x2 mm neodymium magnet 20x1.4 mm

A drill bit with 2 flutes inserted in a tool holder and locked with a pin.

Screwdriver bit holder for 6.3mm (1/4") and 4mm.I printed from TPU.

Check out this tiny desktop CNC bit holder I whipped up!

case for 40 screwdriver bits + cover + holder with recess for 3.5" screws

Center bit holder. Prints in 5h 3min. Printed with ecoPLA (3D Jake). ...

Forstner Bit Set Holder for Harbor Freight 7 pc. ...set - 1/4" to 1" by 8ths.

This is a router bit holder that fits into the Gridfinity ecosystem.

stubby magnetic bit holder using 6x3mm magnet. ...magnets i used: https://amzn.to/4aWfEVI

Holder for eight 1/4 inch bits. ...Attaches in place of a belt hook.

A bit holder is inserted via a high-pressure heat process.

Simple bit holder which I created for a friend.All you need is small magnets.

Magnetic bit holder Needed: 6 pcs 5x3 neodymium magnets 1 pc m3 screw

CounterSink Drill Bit Holder, crafted after a design found on Thingiverse at 2596327.

As the original bit holder fell apart I decided to make my own. ...Because I can.

I created this bit holder for my father's Leatherman utility knife.

A drill bit with 2 flutes inserted in a tool holder and locked with a pin.

Leatherman Arc Bit holder uses the stock 2-56 screws for the pocket clip

A drill bit holder with a cap that holds all of them

this is small bit holder can stay inside the Deburring tool

Holder for my hex bit set. ...A total of 40 bits fit in the holder.

... ...I felt that the bit holder I purchased was hard to insert and remove, so I decided to design it myself. Unfortunately it doesn't work with PLA as it was designed and tested with TPU. ... I designed 6 types of holders from 5 bits to 10 bits.