ecotech vortech mp10 3d models

My printer is sub-par at best, a Monoprice MP10, So I don't get pretty prints most of the time but so far they are strong and durable with PETG. Look forward to more stuff coming out for the TT02! Next I'll be posting the side skirts to go...

... But you can buy me a coffee for my time, or donate to cover some 3D printing consumables. I have a sub-par MP10, so I go through a lot of filament and frequently change nozzles. ... Donate - https://cash.app/$RCPerspective -RC Perspective

 Remix of Basic Phone Stand by Jeremy3DPMS.(Phone Not Included)Print SettingsPrinter:Monoprice MP10 MiniRafts: NoSupports:NoResolution: .175Infill:22%Filament:Inland PLA+Silver Notes: Took about 3 hours to print.Post-Printing...

Kaydee #5s will also work!For best results, I would recommend printing these on a resin printer.You can make do with a standard layer height on any FDM printer though, However, a smaller layer height would result in a better print.In the pictures I...

They should be snug, but easy to fit.You may need to do a bit of fettling to get a nicer fit.I sliced in Cura and printed on a Monoprice MP10 with a modified hot-end (direct drive Ender 3) and used Voxel PLA+ at 210c. ...The knobs in the photos are...

Printed using the following settings: - Monoprice MP10 printer - Cura as the slicer Planter, tray, and roof: - "Fine" preset - Cubic infill - Supports on - Raft Sculpture, columns, reliefs: - "Ultra fine" preset - Cubic infill - Supports on - Raft -...

------------------------------------------------------------------------------------------------------------------------- I use a Monoprice MP10 and its terrible, but it gets the job done and was cheap. So I won't share my settings as they may or...

Parts: Screws: http://www.bunnings.com.au/zenith-4g-x-9mm-zinc-plated-self-tapper-pan-head-screws-50-pack_p2420133 LEDs: http://www.jaycar.com.au/Ecotech/Eco-Consumer-Products/Lighting---LED-Products/Flexible-Adhesive-LED-strip---Cool-White/p/ZD0570...

Ask me if you want some other configuration and maybe I'll make it. Modifications: -Added full size SD tray. -Deepened the MicroSD trays, as there was more room due to the thicker SD slot. -Made the MicroSD Cards fit more snugly by bringing the notch...

I print with a Monoprice MP10 3D printer, which is horrible, but it works, and it was cheap. It printed much better with typical settings on PLA but PETG is a whole other beast, So I won't trouble you with my perhaps erroneous printing settings. ...

I needed to change the bottom to allow access to the Loconet Cable port (because I use a tethered system),and the lanyard attachment to fit in the holder for the Digitrax DT600 throttle.It can also hold the last series of Digitrax throttles: the...

Some notes for printing: * These were all designed for and printed on a Monoprice MP10 which has a 300mm x 300mm build area. As such, some of the trays are quite large. The Huge Card Tray runs 229mm x 146mm and the Terrain Tray is 193mm x 158mm. ... ...

- Chest Side panels of the car mode have been redesigned for a smoother look - Chest Side panels help to cover the back in Robot Mode -Weapons now have a core that can be inserted in to add strength -New weapon handles and stabilizers for a better...