echelon phone holder 3d models
412495 3d models found related to echelon phone holder.
thingiverse
This is a phone/ tablet holder for the Echelon EX-4s exercise bike. I am not sure if it will fit others. This fits into the two small screws on the back of the display. I used two M4 x 12 screws with a washer. For the infill i used modifiers in...
thingiverse
This is a remix of the Echelon EX-15 phone holder by gdeadfan. I reduced the length and height of the phone holder by a few mm for a tighter fit and added two vertical bars for a better hold against the horizontal bar of the bike. Double-sided tape...
cults3d
designed in Shapr 3D as an extra phone holder for my exercise bike. ...it hold on well enough to the bars but i designed it so that a rubber band can provide some tension.
thingiverse
designed in Shapr 3D as an extra phone holder for my exercise bike. ...it hold on well enough to the bars but i designed it so that a rubber band can provide some tension.
thingiverse
This is a shoe holder that slides onto the seat post and allows you to hang your shoes on your Echelon Connect Sport spin bike. Print lying flat. ... The last photo also shows the weight holder found here: https://www.thingiverse.com/thing:4712863
thingiverse
This is a weight holder that goes into the back of the Echelon Connect Sport. I have tested it with 2, 3 and 5lb neoprene dumbells. I used a small amount of super glue to hold the plug tight against the holder otherwise it has a slight wobble. The...
thingiverse
... of shoes off the rear of most models of Echelon Connect Spin Bikes. ...Inspiration was taken from this model here: https://www.thingiverse.com/thing:4712867 As shown in the photos, this accessory is compatible with the OEM Echelon rear weight holder.
cults3d
Phone holder to be printed 2 times one per side several angles available 50°;60°;70°;80 for phone 1.5cm thick modifiable on request do not hesitate to contact me if you see improvements to be made contains solidworks file and stl file phone holder to...