e46 key 3d models

Simple key

Just a key #solidworks

this is key

BMW E46 3D Wall Art by anshjain - Without SpoilerThanks @anshjain for the original model.3mf file edited in blender.

BMW E46 PDC Sensor Delete Plates. ... Old sensor and Holder removed, new plates painted and glued in to reduce weight.

Replace snapped BMW 318i e46 ABS hex nuts with a 3D printed one. ...Use proper automotive filament.

Key to Unshackle the Lock

A replica of a key.

This key unlocked every single door!

Key with a hole for a finger

Actual car size key component prototype

This is a key I designed.

key using pro e wildfire 5.0

A generic key with my kids initials

BMW E46 CABRIO TRIM PANEL COVER RIGHT/LEFT 7022394 51437022394 GENUINE This is a scanned left model of the part with an accuracy of 50 microns

Cap for BMW 3 Series E46 washer fluid reservoir perfectly fits with great friction when printed using high-quality PETG material.

This is replica of original BMW Motorsport Golf Ball Shift Knob for BMW e36,e46 and other with 14mm gear shift level.

Works perfectly as a replacement for my broken vent handle on my BMW E46 325i. ...If redesigned or improved, I'd appreciate knowing about it.

A Basic Wall Key Holder. ... The Wall Key Ring is a Simple Device.

This is repair fix for cracked button mechanism on cluster gauge for clock adjusting. Just cut small remaining pieces from cluster to fit this fix. Print laying flat with supports. ... Easy fix for free (i hate guys selling this on ebay for 40$...I...

Model of my favourite car in the history of cars! Together with the full model I have included a "half-cut" model divided in front and rear, so you can print it more easily. The wheels are inspired by the Fifteen52 Tarmac Cast rims, a very...

A 52mm gauge pod meant to fit into the driver side air vent. ...Fits into the factory vent fin mounting holes.

keychain siluet no cracked

Bluelight scanned the old speaker (Revopoint Mini) to get basic locations, then built a model around the scan in Fusion360. Lots of caliper work. ... The electrical connection was recycled from the original speaker using a soldering iron and inserted...

This is a basic clamp I designed for holding onto my Vanos assembly while removing/replacing the center plungers. It does slip a little, but still holds the assembly all round instead of squeezing a couple of flat spots. Printed at 0.3mm layer...

Remix (ammended) of https://www.thingiverse.com/thing:3443579. Print PETG or ASA. ...100%infill

Keychain that can be printed flat on bed. I had good results with simply using PLA in various colors. Models consist of: -Sedan "body", -Two styles of rims, -Eyelet, -Complete keychain set with rims and eyelet. Eyelet and rims can be placed...

My old beamer needed its first cupholder.

Just a vague model..... ... any suggestions would be very valuable....