derby worx axle bender 3d models

These pins do not come in STL files but can be made out of short pieces of regular 1.75mm filament;- Batmobile can be mounted on a cylinder for smooth and quick rotation or assembled with a cap;Suspension:- The active suspension of the model's front...

The 3D printing model's chosen scale is 1/16 for the FFF/FDM version.VERSIONS SPECIFICATIONSFFF/FDM 1.0 version features:- Contains 99 parts;- When printed the model stands 416 mm tall, 213 mm wide, 919 mm deep;- Minimal recommended 3D printer build...

You don't need a Z end stop switch (since there is no zero on a belt).Everything else should be wired the same.Print settingsEverything was printed somewhere between a 20-30% infill except for the axles which were printed at 60% infill and the...

The 3D printing model’s chosen scale is 1:16 for the FFF/FDM version.VERSIONS' SPECIFICATIONSFFF/FDM 1.0 version features:- Contains 120 parts;- A printed model stands 335 mm tall, 254 mm wide, 670 mm deep;- Fully active suspension system allows...

I think it's obvious where it goes :-) (there's no fitting pictured here, as I don't use one). Use a suitable drill to clean up the small gear's axle hole, if necessary, add an M3 nut to the nut trap on the bottom, and thread-in 6-8 mm pan- or...

Also, I've been wanting to try T-thread screws as axles for filament spools for a long time. Metric nuts and studs are not very suitable for this purpose, as they stop quickly when rotating, they simply go into resonance. T-nuts, on the other hand,...