cr 10 dual z sync 3d models

Raise the CR-10 bed another 10mm to prevent the gantry bracket from hitting Z-motor mount.

<p>just make a copy of the original from tornado</p><p><a href="https://www.printables.com/social/348660-leo-diy/prints">https://www.printables.com/social/348660-leo-diy/prints</a></p><h3>Print Settings</h3><p><strong>Printer...

just make a copy of the original from tornado

a cr-10 stand alone case

Vehicle Registration Plate For Cr-10

Leveling Knob for CR 10 S5

CR-10 Upgrade Extruder Kit. ...Aluminum MK8 Drive Feed Replacement for Creality Ender 3 and CR-10 Series Printers Including CR-10, CR-10S, CR-10 S4, and CR-10 S5.

Longer LK1 Dual Z

A USB cable for the CR-10 printer.

Cable Management Kit for CR-10 3D Printers

Constructing a CR-10 Heatsink in Solid Edge

Logitech Camera Mount for CR-10 3D Printer.

A Compact Hood For Your Display Screen CR 10

Here is a hand grip for the Cr-10.

Hotend for Creality 3D Printer CR-10 V2

Brackets for mounting support struts to a CR-10. The struts themselves are 15mm extrusion. This mod does reduce the z-height by about a inch, so if your somebody that actually uses all 400mm of the z-height this mod might not be for you. ...Also you...

This is a fan duct design for the Creality cr-10/cr-10s/Ender 3 I wanted to share.

I've got a spare T-Bracket for my trusty CR-10 Mini, which I'd been missing all along! However, I noticed that the holes aren't quite aligned with the Z-stop bracket - perhaps it's better suited for use on the opposite side? ...Given my preference for...

The CR-10 extruder is suspended for maximum quiet operation. A set of vibration dampeners are securely mounted underneath to minimize noise levels. The filament is expertly guided away from the z-screw, ensuring a smooth and uninterrupted printing...

remix to add dual z

I have installed klipper in a semi original CR-10, this is what I changed in my CR-10: - extruder (the dual gear red that you can find on amazon) - the bed, the PEI bendable that you can get everywhere - an all metal hot-end clone I have connected a...

... fan cover and its two screws. One M3 10 mm screw is needed to secure the holder in place. The hole for the caliper measures 16.5 x 5.4 mm. Two g-code files are included to assist with leveling on CR-10 (300x300x400) and CR-10 mini (300x220x300).

The CR-10 spool holder relies on 608 bearings for its functionality.

Crafted to extrude unaided, this printer seamlessly integrates with standard CR-10 components.

This was sliced with meshmixer to fit the Creality cr-10

this is a dial/knob for the creality cr-10 3d printer. ... no supprts

This is an accessory designed specifically for the CR-10 Rail System.

This is my maiden voyage in transforming a CR-10 into an EINSY board.

This tool carrier holds all necessary tools within easy reach for the CR-10 system.

I designed these adapters to provide a little extra give when using the Z height on the CR-10. Future upgrades to the control box are also in the works. These adapters allow you to set the PSU directly on them without needing any tools. Simply line...