co2 laser alignment tools 3d models
337365 3d models found related to co2 laser alignment tools.
thingiverse
Designed to lead the tap into place with ease, this precision tool takes pride of place on any workshop bench. A maker's creation, it can be found at https://www.thingiverse.com/thing:2998466. ... Complementing its counterpart, the Tap Holder, it...
thingiverse
... in vintage Heathkit radios, which I successfully utilized to calibrate my trusty HW-16. ...The photo shows the tool after it had been thoroughly employed, resulting in a slightly worn shoulder due to repeated use against the tops of inductor cases.
thingiverse
This handy tool lets you quickly verify where the secondary mirror sits once it's securely positioned in the eyepiece. The inner part features a tiny opening that needs to be precisely sized for your specific scope. ...Depending on how well-printed it...
thingiverse
A personalized variation of the design found at http://www.thingiverse.com/thing:116081 was created using the Customizer tool (http://www.thingiverse.com/apps/customizer/run?thing_id=116081). ...The specifications used for this customization include a...
thingiverse
Use: Ensure x & y are centered & increase Z height to 30mm and then turn off printer Insert tools on each side evenly and manually lower for a snug fit Turn on printer and raise z height a few mm using the printer controls and remove tools That...
prusaprinters
This was irritating in that i would have to open the mmu to line up the filament into the hole feeding the ptfe tube in the mmu selector. So, I made a janky little tool to depress the filament allowing you to line up the filament without opening the...
thingiverse
So, I created a makeshift tool to press down on the filament allowing you to line up the filament without opening the MMU2 cover. Simply use the narrow end to press down on the filament between the PTFE feeding tube and the entry into the MMU2...
pinshape
This tool holds the filament securely while measuring, allowing for accurate readings every time. The design features two holes to accommodate both 1.75 and 3 mm filaments. Printing without accurate measurement has led to problems such as clogging,...
thingiverse
For this I have constructed a tool with which you can check whether the track is maintained.For this you need the following:Aluminum U-profile 6x6mm 500mm long (my profile has 5,8x5,8mm, this is also good, so that the ball bearing fits on it)ball...
grabcad
with this data you can build your own homemade CO2-Laser. ...If you have questions, please contact me
thingiverse
... Hope you find It as usefull as I do. for a perfect 90° angle of the line, lay the tool on the ground facing the laser forward. Then hand a string from a desk or simullar and rotate the diod until the string and the laser line are aligned.