cirkul lid 3d models
66200 3d models found related to cirkul lid.
thingiverse
... ... Use the settings to change this object: Customizer - Customization Options Storage Box Instructions Using these parameters: Lid Thickness - 0.2 inches X-width (inner dimension): 1.4176 feet Y-width (depth): 5.666 feet Add a Lid? Yes, add it.
grabcad
A hot pot lid is an essential accessory for any kitchen, ensuring that your delicious stews and soups stay at the right temperature while preventing unwanted spills or splatters. This versatile piece can also be used as a serving dish or a trivet,...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=56910 Instructions Using the following settings: Lid Number of Sides: 1,000 Part Type: Lid Gap Size: 0.08 units Resolution: 60 points per unit Inner Diameter: 25 units Minimum Wall Thickness:...
thingiverse
... ...It was created using Customizer! with specific settings, including Rim Thickness x 10 of 7, Smoothness level set to 60, Rim Height of 3, Lid Wall Thickness x 10 at 15, and a Diameter Including Top Rim measuring 75. ...Check it out for yourself!
thingiverse
Key dimensions that will influence the final shape include the inside diameter of 16 units, a minimum wall thickness of 1.0 unit, an interior height of 5 units, a lip height of 3.0 units, a bayonet depth of 0.4 units, and the lid or top's material...
thingiverse
Customized Version of Thingiverse Design: https://www.thingiverse.com/thing:612709 Generated with Customizer Tool: https://www.thingiverse.com/apps/customizer/run?thing_id=612709 Design Details: Using Options: lid_top_thick = Negative Value Not...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=43899 Instructions Using the Following Options: thickness is Set at 5 depth is Set to 75 width is Set to 70 wiggle room is Set to 1 height is Set to 80 flange height is Set to 2 filament...
prusaprinters
Lid to keep all the caps in place when storing. It is designed to be a exact fit to the board so depending on printer and slicer settings it might become either too tight or loose. ...Printed on my Ender 3 with a 0.8nozzle and sliced in Cura with...
thingiverse
I took a couple of designs and remixed them into one design. ...I put them at a 45% angle so that I could stack two of them.
thingiverse
Simple remix of the original version.I separated all parts so there are not supports needed to print this. ...Everything locks in pretty well with just pressure (if you want to be extra sure, just use a drop of super glue).I removed some un-need...