big rim 3d models

big rim

big rim

big rim

Big Rim

CSWA Big Rim

A big rim.

Big rim model

A big rim

The Big Rim is inevitable.

Big Rim part for CWSA

3D model of a big rim.

3D model of a big rim.

A big rim that I made using SolidWorks 2020-21

A big rim that I made using SolidWorks 2020-21

I used the sketch tool to make detail E then I used the revolved boss tool to make the sketch into the 3D big rim. ...Mass = 112862.37 gramsVolume = 41800876.90 cubic millimetersSurface area = 1789353.33 square millimeters

Mass = 112862.37 gramsVolume = 41800876.90 cubic millimetersSurface area = 1789353.33 square millimeters- 160 alloy is the material To create the big rim, I started with seeing how My teacher started and then I basically went with dimensioning...

... millimetersFor this model, I started by using the sketch tool on the right plane. ...I used the line tool and trim/expand tool to get the desired shape. Once done, I used the Revolved Boss/Base tool to make the drawing 3D. Leaving me with the Big Rim.

Mass = 112862.37 gramsI started with a half sketch of what was half of the big rim. I made the bottom according to the dimensions (140 by 100) and then started working on the top which is 450 away from the bottom line. I used mirroring while doing...

Another desain rim for big vehicle

I made the 2D version of the figure first the revolved the Rim.

I used the line tool to create my shape, I only made half of the rim because I revolved the shape. ...I had to make the angles correct, cut some of the front face off so it would look perfect

First I 2D sketched half of the rim and extruded the sketch to different heights. ...Then I used the draft tool to angle the inside circles edges and the outsides circles inner edges.

... ...Made a vertical center line then used to the dynamic mirror entities to start my sketch.2. Drew a sketch of the shape of the Rim.3. Gave all the lines their corresponding dimensions.4. ...Used the Revolve tool to mirror the sketch around the origin.

... back to the bottom rectangle and the middle one, their inside corners should be 105 degrees as well as the ones between middle and top rectangle. The entire height of the rim is 450. ...Finally revolve the sketch, it should have a diameter of 900mm.

Then, I measured out to 20mm on both sides and trimmed the rest of the big line. On to the bottom portion, I created another line on both sides that measured 100mm and created a horizontal line to 140mm to finish the sketch. Next, I revolved the...

big rim

I started this model by sketching only half of the front profile. ...I then revolved the sketch 360 degrees around the top plane to create the circular model.

CSWA Exam study

I started this model by sketching only half of the front profile. ...I then revolved the sketch 360 degrees around the top plane to create the circular model.

scissor lift