battlebots duck 3d models

The BLTouch felt like a sitting duck way out in front. Then I found [windischb's H2 mount for the Ender 6](https://www.thingiverse.com/thing:4762042), and I started to salivate. Dual fans, mounted up high and ducted down so they don't block...

This might seem obvious, but it may not be; the led's needed to be mounted securely, and the front was too thin at that point. added: (same as for the LEDs) more plastic for the display to mount in. changed: re-created the screw holes for the...

## My setup I have an early Easythreed X1 without part cooling fan, and instead I used a PC 120MM fan standing next to the printer or 4010 centrifugal fun with simple duck, both connected to fan header in the electronics box. They unfortunately...

While the Smith household is terrorized by ridiculous alien parasites, the whole family needs to be on the lookout for fake relatives, Big Ducks with muscles, baby wizards, ghosts in the jars, reverse giraffes, etc. Thus, Rick Sanchez revealed his...

The enclosure width is now 450mm, still wide enough to hold an ender3.Frame assembled (upside down until I get the skirt corners and feet installed):(finally got my ducks in a row and built the frame *badum tish*)To further increase the frame...