baofeng volume knob 3d models
62558 3d models found related to baofeng volume knob.
prusaprinters
A Baofeng UV-5R Wall mount that uses the clip of the radio to hold onto the mount, attached to the wall with 2 to 4 screws Note: I do not recommend using adhesive tape, because the radio is heavy enough that it could pull down the mount over time...
thingiverse
This stand is specifically designed for use with both the BaoFeng UV-5R and BF-F8HP radios, featuring two distinct models: one with a standard battery capacity and another upgraded version that boasts an extended 2100mAh battery life. The design also...
thingiverse
... Potentiometer Knob is Designed to Fit Shafts with 6mm or 1/4 inch Diameter. ...The Knob is Press-Fitted in Place. Originally, This Knob was Intended for Guitar and Guitar Pedal Volume Controls, but You're Free to Use it for Any Purpose You Desire.
thingiverse
For quite some time now, I've been searching for a way to run my Baofeng on batteries that can be recharged in the field using a solar panel or other USB device. Since I use an 18650 battery charger as a power bank and run my headlamp on an 18650,...
thingiverse
PTT holder for a friend's Baofeng radio. Not sure the exact model he got, it was some generic one from AliExpress, there's a bunch of similar models floating around, if I find a link to the exact model he's got I'll put it here later. The one in...
thingiverse
It covers the PTT, 2 programmable buttons, and the light between the volume knob and the antenna. Use a rubber band to secure it to your radio. I made this because the UV-5R covers would not fit the RF-S5 Plus. ...If you want to contribute, send funds...