balon ball valves 3d models

I bought 30x100cm plywood, built sled at 5deg angle so I could cut them with easy and reproducibility.Plank cutting line - sled can be seen in the back.After cutting stack of planks I drilled holes and countersinks so bolts will flush nicely.After...

Both versions are to be identically assembled to the body of the bike;- The assembly of the front and rear shock-absorbers requires 2 regular ball pen springs and additional "pins" made out of short pieces of regular 1.75mm filament;- Rotation of the...

Put something insulating between Step-Up module and the LCD main board like ball of paper, piece of rubber, cardboard. This will fix the LCD main board, so chose wisely :) Puth the charger module in place (upside down, remember), fix it the pace...

Similar to its TIE line predecessors, 3D printing TIE Interceptor has a ball-shaped cockpit equipped with an ejection seat for a single pilot. The “eyeball” is suspended between two heavy wing pylons that are attached to Interceptor’s distinctive...

acetone vapour bath and Acetone polishing)Clear/Transparent filaments (DO NOT EXIST!)I wanted the helix to be transparent so one could see the ball move up within. Needless to say I have a big difference of opinion with filament manufacturers on what...

The author of the droid model for 3D printing made sure to carefully emphasise all the distinct lines and details that the body of the ball-like robot is adorned with. Naturally, BB-8 for 3D printing is equipped with a set of tools that can be...

because the M5 have bigger heads and allow a more powerful tightening), you will need at least 50, I advise you to take 100 lol, it goes quickly!In the end, I advise you to buy, a complete box of screws of different dimensions to have a lot of...

Ainsi, ils attaquèrent le petit groupe et Reed reçut une balle dans la jambe, avant d'être pris en otage dans leurs cavernes souterraines. Il fut libéré par le capitaine Archer qui réussit à dialoguer avec les Noviens. (ENT: "Terra Nova") Il...

The ball's a little grabby. That's where I usually sit. Right... there. Ken, Barry was looking at your resume, and he agreed with me that eating with chopsticks isn't really a special skill. You think I don't see what...