arrma kraton 6s v4 3d models

Arrma Raider Shock Tower Item Print Settings Printer: K8200 Infill: Ten Percent

Arrma Granite plugs below servo to avoid dust and rocks entry from there.

Raider Steering Servo Mount by ARRMA Print Options Printer: K8200 Infill Rate: Set at 10 Percent

this is a front grill for arrma infraction that will hold 17mm light (no glue needed)

RC GANG 93 Protection for the rc 1/10 ARRMA GRANITE 4X4

The ARRMA Raider comes pre-built and ready to roll out of the box.

ARRMA Raider Shock Tower Front...\nPrint Settings\nPrinter: K8200\nInfill: 10% Print Level

Hood protector for the Arrma Big rock designed for M4 dome hex screws

Arrma Limitless Hammerhead Front Wing Here is a video: https://youtu.be/KuofdArAWRU

RC GANG 93 Front grill for ARRMA GRANITE 1/10 RC Monster truck

Crashcase for the Firefly 6s drone.

To scale model of iPhone 6s +

iPhone 6S case in a mandala style.

Arrma Vendetta bearing support remix. ...I widened the support to make it a bit stronger. Credit to camaroboy383 for the original design, it holds the bearing tighter than the stock Arrma bearing holder. Printed in Clear Esun Petg. ...Use supports.

These skid plates are meant for the roof of an arrma senton 4x4. ...There are two models one says Senton and the other one says Arrma. Other than that there is no difference between the two. ...

This is an axle stand for 1/7 scale Arrma or any other R/C with 17mm axle studs. ...

Arrma side skirts for the Infraction. I split the files to fit on an ender 3 . ...printed with PLA .

Arrma Raider Front Steering Hub Mirror Object For Both Sides Print Settings Printer: K8200 Supports: Yes Infill: 90%

Print with TPU. ...Fits on Arrma Felony rear tower. ...Open small hole through body to see from the outside.

Lexichi V4 from vrchat

V4 Engine block

This servo mount gives you a place to install an ESC into the Arrma Grom when replacing the stock ESC/receiver unit. ...Reuses all stock hardware.

Cutout the inner shape from the arrma body on top of the fenders and glue from bottom. ...adds airflow in the shell for increased cooling.

These cables are originally designed for use with the Arrma 3s 4x4 Senton and Typhon models, specifically to manage the motors.

Temperature sensor mount to fit in rear bumper for a Arrma Street Mojave. Probably too exposed for a basher Mojave. ... Use TPU.

Arrma Rear Shock Tower prints successfully on K8200. The K8200 supports printing with no limitations. ... A 10 percent infill setting is used to create a sturdy structure.

ARRMA Raider Front Steering Link Create a mirrored version for both sides to ensure perfect symmetry. ... Configure Print Settings as follows: Printer: K8200 Infill Percentage: 10 Percent

The K8200 printer is set up to print a design for an Arrma Raider rear suspension mount. ...The infill percentage has been selected at 10%.

Front canard wings for the Arrma Vendetta. The canard end plates get super glued to the canard wings after printing. ...I printed in Petg.

Battery wire hold for Arrma BLX models with center brace bar. Pictures of it on a Kraton 4s V2. ... one side it .1mm smaller so it threads on the treaded part of the brace to keep it from sliding around.