armory forged shell 3d models

Don't forget to install the stepper driver jumpers. Update 7-4-2017: The top and bottom clam shells did not fit without pushing the LM8UU bearings slightly out of alignment. I removed a small amount of material from the top clamshell to allow...

with a 0,50 width, set to 3 to have a 1,5 mm perimeters shells - First Layer Height: set to a value greater than 100% to have a first layer taller than Primary Layer Height and viceversa - First Layer Width: set to a value greater than 100% to have a...

I wanted the walls and areas around screws to be solid..2mm Layer Height4 Shells.4mm Line width5 bottom layers5 top layers20% InfillPrinted all the chain links together duplicated as a single print job. I printed a few extra just in case any had...

Modified settings: PrusaSlicer > Print Settings > 0.20 QUALITY MK3 > Layers and perimeters• "Ensure vertical shell thickness: disabled" - I had problems with thin 45° hanging angles when it was enabled.• "Perimeters: 6".• Seam position: Rear - I...

I used a light green for the stem and leaves, and red for the pot. All parts were printed with the following parameters: 0.2mm layer height 2 outline shells 3 base layers 3-5 top layers 5-15% rectilinear infill Servo Preparation This projects...