anycubic kobra usb 3d models

Default settings and not set explicit in this cfg ######################################## # basic settings ######################################## [mcu] serial: /dev/serial/by-id/usb-Klipper_stm32f407xx_220040001651383230343230-if00 [printer]...

This could have potential consequences (pun intended) if both cameras were connected to different mains-powered equipment like studio strobes, or PCs over USB.It's difficult to conceive of a fault scenario for solely battery-powered equipment.Editing...

You should be able to attach the usb cable and connect to pronterface using the correct com port (which should auto install on your pc when you connect it to the ramps board) and baud rate 250000. If this doesn't give you a stable connection then...