antique pulley 3d models

This would be serving up the filament with practically no "bends" (which when acting as pulleys can really increase workload) and over a much shorter distance. I've been running the new configuration (see photos above) for many hours of printing on...

If you're looking to replace your belts and pulleys to “industry standard” GT2 this should be happy news. The tensioner needs an M3 heated insert installed (or M3 nut) and the belt peg a 30 mm M3 socket head through it, I will not cover this in...

The plate's top edge stuck up too far and pushed the belt position upwards, causing the belt to grind on the nearest idler pulley from the bad alignment. I increased the depth of the cutout to give more room for the belt. I hope that works because I...

This would be serving up the filament with practically no "bends" (which when acting as pulleys can really increase workload) and over a much shorter distance. I've been running the new configuration (see photos above) for many hours of printing on...

http://www.thingiverse.com/apps/customizer/run?thing_id=53235 Instructions Using the following options: gammaTooth = 2.3125 MusicCylinderName = new song axisSlack = 0.6 midBigTeeth = 21 pulleySlack = 0.45 gear_gap = 1 snapAxisSlack = 0.3...

The angle of the PTFE this way exactly follows the path of the entry hole angle around the new pulley design on the MMU3 buffer.   BOTH BUFFERSIf you look at where you are now it should look like this from above. I places some spool holders here for...

https://www.thingiverse.com/apps/customizer/run?thing_id=53235 Instructions Using the following options: crankGearAngle = 15 crankAxisR = 3 gear_min_gap = 0.1 GENERATE_MUSIC_CYLINDER = 1 gear_tolerance = 0.1 $fn = 32 GENERATE_CRANK = 1...