angled curtain rod holder 3d models

This is an angled (45 degrees) curtain rod holder that fits a broomstick with around 23.6mm diameter. ... It's a snug fit so if you want some wiggle room print it with a couple percent above 100.

Custom Curtain Rod Holders.

just a holder curtain rod

This device allows you to install the shower curtain rod at an inclined wall. It's a bracket featuring a built-in 22 degree tilt, attached via an IKEA-made hook with suction cup. ... The IKEA-made hook can be purchased on-line from...

Curtain rod holder to put light window or door curtains.

Curtain Rod Holder, Two Convenient Sizes Available

This rod holder accommodates one-half inch metal curtain rods.

90 Degree / Perpendicular curtain rod holder for a 1/2 inch curtain rod

two-part curtain rod holder, easy to remove

curtain rod holder for 10 mm pipe. ...Printed for a mosquito curtain for caravan door.

This little Thing is a small curtain holder designed for a 1cm diameter curtain rod.

curtain rod holder round rodfor 10 and 12mm diameter tubewith holder for center support

hi all Just a simple curtain rod holder diameter 19.50mm

hi all Just a simple curtain rod holder diameter 19.50mm

This is a curtain rod holder similar to those utilized in recreational vehicles.

Curtain Rod Holder Print Settings Printer: RebelIX Rafts: Irrelevant Supports: None Notes: Material: PLA

For Curtain Rod 13 mm

This window curtain rod holder is a substitute for an outdated single piece from an IKEA window curtain ensemble, unfortunately without the product number.

Curtain Rod Holder - Tailored to Your Needs Crafted with precision using Openscad, this customizable curtain rod holder is still under development. ...Feedback and suggestions from fellow makers are highly valued.

Simple curtain rod holder. Printed as is, fits up to 19mm in diameter pole. ... Print on its side.

Industrial Strength Holders Made From Steel That Accommodate 16 Millimeter Diameter Curtain Rods For A Secure And Sturdy Grip.

Curtain Rod Holder. Prints exactly as shown, accommodating poles up to 19mm in diameter. ... Face down, print flat.

Couldn't find a decent curtain rod holder for cheap dollar store curtain rods. So I designed these and they work great. ...I used PETG for strength and 100% infill.

Vertical curtain rod holder Designed for : - rod : 14mm - screw : 4mm - srew head : 9mm Printed on Ender 3 V2 NEO with PETG at 220°C

I'm designing a custom corner curtain rod holder that fits snugly into tight spaces, accommodating rods as small as 0.75 inches or 20 millimeters in diameter.

Wall-mounted Double Curtain Holder.

This piece slides onto a curtain rod on one side and clicks into a preexisting holder on the other, connecting the two in case the curtain used is too short to reach the holder. 

For our sleeping room we need a special holder for the curtain rod. ...Usual holders are not fitting because it is a dormer window.

Quick Fix Curtain Rod Thread Organizer. Curtain Rod Width 1/2 Inch. ...More Views Ahead

The newly designed curtain rod holder grips a sturdy 16.0mm curtain rod firmly in place, with precision-drilled holes spaced 25.0mm apart to ensure a perfect fit. The top hole features a strategically cut slot for added stability. The carefully...