45 degree curtain rod 3d models

rail support or curtain rod clips.

Solidworks tutorial Grease nipple M8-45 degree

This rod holder accommodates one-half inch metal curtain rods.

Curtain rod end Compatible with 2cm diameter rod

Curtain Rod End Fittings for 20mm and 16mm Curtain Rods are Available Now!

Quick Fix Curtain Rod Thread Organizer. Curtain Rod Width 1/2 Inch. ...More Views Ahead

Curtain rod end for 20mm curtain rod Tope de barra de cortina para barras de 20mm

DN50 45 degree elbowStandard: DIN EN-10357 (series A)

5 slot 45 degree canted scope mount. ... Requires 2no M5x25

Needed a 45 degree tilt and not so many outputs.

DN50 45 degree elbowStandard: DIN EN-10357 (series A)

45 degree gopro session mount 30.5x30.5

45 - degree adapter for mounting your Abode Cam-2, enjoy!

This little Thing is a small curtain holder designed for a 1cm diameter curtain rod.

curtain rod holder for 10 mm pipe. ...Printed for a mosquito curtain for caravan door.

I needed a support for my new curtain rods.

# Shower Curtain Rod Holders Made for a 20/21mmØ tube

curtain rod support. ...Takes 1 kilo without problem.

Brackets to hold 32mm and 25mm curtain rods.

New cat curtain rod mounts with pre pierced holes.

Nestable cap on curtain rod of 16mm diameter

Rhombus end cap for curtain rod with 25mm tube

two-part curtain rod holder, easy to remove

Valance Clip replacement for old style curtain rod wood cover.

curtain rod support diameter 28mm + support cover.see attached pictures

Brackets to hold 32mm and 25mm curtain rods.

Curtain rod adapters make it easier for curtain hooks to slide along rods with more ease and efficiency.

Two unique-sized curtain rod holders keep the curtain rod tightly secured against the wall, significantly shorter than typical brackets.

1x curtain rod end 19.75mm rod diameter 1x curtain rod end 16.5mm rod diameter 3mm hole for headless fastener

To prevent that damage, and to still have a way to attach the rod for the shower curtain, I made these mounts. I printed these at a 45* angle, with the rear facing downward and the bottom down. It needed supports from the baseplate, but not anywhere...