3mm d shaft 3d models

267417 3d models found related to 3mm d shaft.

35mm + 16mm Sprocket Roller Package (1/4" d-shaft bore)
thingiverse

Human: 2 models are available: - A 35mm + 16mm film rolling sprocket - An independent 16mm film rolling sprocket Both feature a 1/4" diameter shaft axle bore. Note the sprocket teeth on the larger roller have been intentionally tapered at a 23-degree...

Magnetic Slip Clutch for movie reels (6mm D-shaft to 8mm square shaft)
cults3d

The input side accepts a 6mm D-profile shaft and the output side features an 8mm square shaft for mounting the reel. In addition to the printed parts, you'll need 1 x washer (I measured around USS 1/4" dimensions, but you can use a drill to remove...

Axle extension 6mm shaft (4,6mm) / Achsenverlängerung D-Achse
thingiverse

This is an axle extension for 6mm shafts, cut down to 4.6mm. Total length is 52.6mm, total diameter is 12mm. The object was designed and printed for my mother-in-law for her oven. I know 70% inlay is very much, but I wanted to achieve the maximum...

Propsaver - model plane prop saver for 3mm shaft and m3 drive nut
thingiverse

The Prop Saver fits snugly onto a 3mm shaft with one M3 nut securely driven into it. To secure the propeller in place, loop a rubber band or an O-ring around the prop and Prop Saver, holding everything together. This setup should allow the propeller...

Magnetic Slip Clutch for movie reels (6mm D-shaft to 8mm square shaft)
thingiverse

The input side accepts a 6mm D-profile shaft, while the output side features an 8mm square shaft for secure mounting of the reel. To assemble this project, you'll need several additional parts beyond the printed components. ...These include: 1 x...

GT2 Pulley 24 Teeth - Motor Shaft 3mm - Belt width 3mm
thingiverse

GT2 Pulley 20 Teeth - Motor Shaft 3mm - Belt width 3mm
thingiverse

D shaft coupling piece fitting Ø7mm shaft
thingiverse

**Data Specifications** Outside casing: Ø10mm Inside casing: Ø7mm Inside casing, cross section: 5mm "Pre drill" holes for pinol: Ø1,2mm **Purpose of this build** Coupling piece for an old microwave turntable motor. Building a marshmallow...

GT3 - 3mm pitch - 16tooth -6.35 shaft
thingiverse

3mm to 3 mm Shaft Coupler
thingiverse

Customized version of https://www.thingiverse.com/thing:964680 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=964680

8x6 - shaft 3.3mm - 25 max cord
thingiverse

Motor shaft adapter 3mm to 5mm
thingiverse

I used this adapter for my RC Speed Tank by Bryant87. It converts 3.125mm axles to 5mm axles. To get the best fit, start with default print settings and adjust flow as needed. Ideally, there should be no noticeable play. There are three versions...