3d printed graduation cap

... slip on the 8-toothed pulley. Some adjustments might be necessary based on your printer settings. Note that the picture quality of the pulley cap is not up to par due to changes made in E reversal settings to combat residual blobbing and strings.

A flat washer with a square hole attached needs to be glued on the long end of a printed rod that will go through this CPVC's end cap hole as it rests just against its outer surface when not in motion and can hold an additional part back, thanks to...

Candy cup holder for graduation open house.

These changes have been made before the deadline of the 3D Printing Event Challenge. Mod A (1st Sept 2012): As suggested by Luke (Luke) I have changed the end screw cap. Instead of a little tab a rectangular though cut allows a flat head screw...

3D 列印組件 修改零件 3D printed components modify parts

Creating a 3D PRINTED STAINED GLASSComponents Used: only 3d printer

3D printed components modify parts 3D 列印組件 修改零件

3d-printed brushless DC electric motor.

Student designed rings to be 3d printed

3D printed Speaker driver Work in progress

Student-designed 3D printed airplane for 3DPAC.

3d printed cat. ...Original design.  have fun. 

3d printed enclosure for the electronic device.

Designing a Timepiece with 3D Printing Technology

Print my 3D Printed Slide! ...Instructions on the panel.

Fully adjustable, simple to print and assemble 3D-printed vice

Components Required: 608ZZ bearings (2 units) 4-40 hex nut (8 units) 4-40x5/16 screw (8 units) or 4-40x1/4 screw (recommended) Resource Links: http://ericprints.blogspot.com/2017/01/gyroscope-3d-printed.html http://ericprints.blogspot.com/...

Measuring units are meters; the model's size measures about 27 cm in length and it's ready to be printed. The mesh is perfectly manifold, featuring no bad contiguous edges. ... Available formats for the model include .blend, .fbx, .stl, .obj, .dae,...

The container consists of three main structures: a printed tubular body, two sealing caps that also contain temperature and pressure control hardware, multi-layer insulation to protect the container from the sun and space.The tubular body has been...

SIMPLE DESIGN FOR MY 3D PRINTING WORK STATION

This lamp can be 3D printed. ...Made in fusion 360

A simple 3d printed hanger attachment for warehouse racks.

A manifold holder was created through 3D printing.

3D printed case for the BM43, standoffs required.

Create your own 3d-printed greenhousehttps://mysmartgreenhouse.org/

A simple 3d printed hanger attachment for warehouse racks.

Component Number 26, Crafted through Precise 3D Printing Techniques

This lamp can be 3D printed. ...Made in fusion 360

https://maxrottensteiner.at/wordpress/wordpress/3d-printed-pressure-vessels/

Fully 3D-printed pegs for pegs and jokers