3d number 3
2290657 3d models found related to 3d number 3.
thingiverse
I illuminate my RepRap 3D printer's control panel with it. The LEDs require a 12-volt power supply which can be supplied by the printer electronics (Rumba Board). Material: ABS, 3mm thick Nozzle: arcol.hu hotend v4.1.1, 0.35mm diameter Printer: DIY...
prusaprinters
The modules with the lid are great for tall objects (remotes, bottles) while the lift modules are perfect for coasters or other small objects that you wouldn't want to reach in too deep to grab.I also wanted a project that would challenge my limited...
prusaprinters
Ihr müsst die Kabelfarben dazu in der Reihenfolge umdrehen:Blau-Rot-Grün-Schwarz -->> Schwarz-Grün-Rot-BlauDanach noch den Drucker Kalibrieren zwecks ausgebauter Pinda und##################### FINISH #####################oberster Stecker auf...
thingiverse
Instructions Using the following options: thickness=1 nozzle=.4 holeRadius=2 target_diameter=80 scaleFactor=1 steps=6 wide=5 branchy=5 sharp=8 full=5 fuzzy=5 ringed=5 scaleFactor=1 random_seed=2800985 thickness=1 custom_seed=0 long=5 fat=2 organic=3...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=296804 Instructions Using the following options: border_height = 15 image =...
thingiverse
I plan on converting the whole station from spare parts to all 3d printed. Even though it doesn't show in the schematics, some of the sensors are doubled for redundancy and to check each other. Updated 8/17/18: Since the original I made back in...
thingiverse
CHAPTER 3 It was a warm spring night and I sat at a table on the terrace of the Napolitain after Robert had gone, watching it get dark and the electric signs come on, and the red and green stop-and-go traffic-signal, and the crowd going by, and the...