2x scope 3d models

Initially I wanted to use four 100% springs and 2x a spring at 75% (for the tail so that it moved more).I ended up replacing 2 100% springs for 2 scaled at 75% because the movements were not to my liking. I had to add unscaled insert to both springs...

The individual units are 2X the size of the "BaseExample.stl". Scale them up to make as big of a base as you want! There are 3 different connector sizes so you can mix and match the units to the needs of your base, and have all the units connected as...

Drill a small hole the size of the PC4M10 screw.Insert the PC4M10 into the dry box washer on the outside of the box.On the other side, screw the box interface in the PC4M10.Then insert the spooler into the box interface, it is easy to remove.To...

It is available at the link below: https://www.thingiverse.com/thing:3638866 A 12864 Mega328 ESR Transistor Resistor Diode Capacitor Mosfet Tester module with two adjustable DC-DC buck converters (with LCD displays). (pending, but available at...

Furthermore there are exported STEP and Fusion360 Archive Files ready to download.BOM3D Printed Shell (STL folder for models)Elecrow 5 inch Display (If you want to use another display, make sure to adapt the shell)12x Adafruit Softbuttons1x 5mm...

Rough up the outside surface of the tee with 220 or 320 grit sand paper, wash in soap and water, dry thoroughly, and use something like Rust-Oleum 2X Ultra Cover Gloss Black Spray Paint and Primer In One spray paint. Apply two or three light coats of...

Also suitable for impacient makers or if you are in a hurry for printing a present.Printing the PartsI have printed all parts in PETG using these colors:blackyellowtranslucent bluetranslucent green (two different shades)translucent red or...

Minimum Build ------------------- At the very least, you need the following parts: * 1x 4-Way_Planting_Module_Hollow_Twist.STL * 1x Dispenser_Module_Internal.STL * 1x Filling_Cap.STL * 1x Filling_Cap_Symbol.STL * 3x IKEA_Muskot_24cm_Petal.STL * 1x...

Use your soldering iron to install the two M2.5 threaded inserts, but try to make less of a meal of it than I did, lol.Bend the wires out of the way of the travel of the trigger.Once you're done, screw the trigger cover down using the M2.5 screws.It...