1up nrv 3a 3d models

Wall Decor" href="https://www.thingiverse.com/thing:5195100" target="_blank">                                     ...

Then fix it on the wall with nails or screws or use double-sided tape. To achieve the wow effect, you need to place an LED strip on the back of the decor.   My some other things:                       ...

(the base is not needed at this time).* 3a. IKEA legs attached horizontally first. Four (4) IKEA legs go in horizontally (to extend the height). These go in between the "Top Extenders" and then are attached to them by screws (and screwed to...

If you have installed the latest firmware, you have the possibility to reverse the direction of rotation of the extruder without needing to touch the wires, go to the settings, keep the button pressed for 2 seconds, a new menu appears, click on...

Connect the wires as shown in the wiring diagram:ArduinoStepper DriverStepper MotorD11EN D12DIR D13STEP 3V3VIO 5VVM GNDGND near VM  M2BDark Yellow M2APink M1ABright Yellow M1BBlueOptionally you can remove the small resistor besides the red pwr LED so...

The correct cable orientation for this is as pictured: Blue, yellow, green, red.Crimping done!Mount the two small hotend screws to the the hotend mount and tighten it with the hotend sitting behind it. Look at the picture for the correct orientation....