tywe3s 3d models

Very simple programming jig for ESP12 or TYWE3S. Uses 22AWG solid core wire. Use a small spring clamp to hold in place. ... Inspiration from digiblurDIY: http://y2u.be/qMpKzZHSh2Q

Notable changes: - Pogo pins are moved inward slightly as I found that even with the largest tipped pins, they didn't reliably contact the pads on the TYWE3S, and on the SS01S, TX/RX/GPIO0 are not soldered to the underlying board - Added notches so...

Previous version available at: https://www.thingiverse.com/thing:3229822 Programming jig used to mount/align pogo pins for programming ESP8266 or TYWE3S such as used with WiFi home automation controllers and other DIY microcontroller projects. ... ...

Similarly other adapters on Thingiverse were obstructed by other components that were very close to the TYWE3S module. This adapter uses pogo pins and test leads to connect to the chip pins. The top of the bracket opposite the chip keeps the...

Programming jig used to mount/align pogo pins for programming ESP8266 or TYWE3S such as used with WiFi home automation controllers and other DIY microcontroller projects. Designed in SolidWorks. i have two sizes for different sized pogo pins or...

Existing model https://www.thingiverse.com/thing:3231225 is too big for module like this: https://s.click.aliexpress.com/e/_d7tJGEP Therefore had to make own version.

This is adapter easily that connects to the ESP8266 pins. A bare ESP8266 module fits inside to allow easy breadboard access. You can also fit it over the top of a ESP8266 module that is already soldered to a circuit board. Requires - 2 eight...

I had shorter pins than Stephen, so needed a shorter adapter. Fortunately, he included a very nicely parameterized freecad source file. ...I was able to adapt it with just changing the height, and tweaking one parameterization.

This part is remixed from Stephenlofgren. It uses male to female dupont connectors and small pogo pins. I found that the large pogo pins would touch the metal cover next to the pins so I decided to use smaller pins. I inserted the male pins on the...

Using this jig on tuya (TYWE3S) module and help of flashing software like Tasmotizer, eptool.py, one can easily flash tasmota (or esphome) bin to the tuya module. Which then can be easily integrated with Home-assistant (or similar) apps. ... For...

just a remix of net813 flashing jig with slightly thicker walls. ...my slicer would not do the walls correctly.

Inspired by the TYWE3S soldering jig, this one is made for the similar TYWE1S Tuya chip and made in Fusion 360.

I used the following Pogo Pins (Uxcell P11-J): https://www.amazon.com/dp/B007Q8JILQ Pin dimensions (±0.05mm) Body Diameter: 1.0mm Tip Diameter: 0.7mm Height: 24mm (uncompressed) I used this 'Chip Bag Clip' as the basis for the clamp:...