goped models
1812405 3d models found related to goped models.thingiverse
98 Tooth, 2 part assembly, fits all standard electric model Goped ESR scooters, Works great! I am still running these after 2 years. Minimal wear printed with a strong infill and PLA! ABS may yield better results. I run this with a standard...
thingiverse
Goped Gas Tank Spacer Made this for Goped Bigfoot and Sport, May work on other models. ... Not for resale
grabcad
Designed for stock Goped pole, cut off original bar and replace with this stem.Can use standard BMX bars or aftermarket goped bars.
thingiverse
Using neodymium magnets instead of compression springs for this Kickstand. ...Custom designed for my Goped Knowped. ... Instructions Printed with PLA, 20% fill, 0.2mm layers.
thingiverse
This is a cable clamp for a GoPed brand scooter. I designed it years ago but never uploaded it. ...It fits stock poles.
thingiverse
Goped sport rear fender 4mm thick 5 inches long by 2.75 inches wide. i made this to fit on top of a common issue with the rear fender breaking . I used hot glue to secure it on top of the half of rear fender left. ...print it 100 percent infill with abs...
thingiverse
Clamp for stock pole. ...Uses M4 Bolts. PNW CREW logo ( only issue). I did not make this model it was given to me awhile ago. ...
grabcad
Cable clamp for stock Goped pole.Its split into 2 parts, use 2x M2x30mm Hex Cap Screw.Screw should make its own thread.For 3D printer.
thingiverse
XT90 Fob Cover / XT90 Switch Holder - I turn the GoPed on and off using an XT90 which switches the voltage of the batteries through to the rest of the gear, this provides a mechanism to hold the XT90 and provides a nice neat fob for the XT90 plug. 8S...
thingiverse
Decided to replace the broad knowped deck with a slim plywood deck. So I designed a new Fender Brake :) Test rode the Knowped and the fender brake works fine. Instructions First, got to get a...
grabcad
I don't have time to machine the parts that I wanted to because of college and life, so I decided to let someone else use these DXF's for their custom parts. This is an outline of a GP 460 flywheel cover, measurements were done on a Mitutoyo CMM...
thingiverse
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner and the...